LCR-TC1/ LCR-T7/ T10H Transistor Tester Multimeter

If the quality problem of the product is found after receiving the express, please do not open the dispute at will. Please contact our after-sales customer service to solve it in a timely manner. Thank you for your support and understanding!

Cautions for use

• The capacitor shall not be tested without discharge
• The inductance of the transformer cannot be tested
• Don’t test online with electricity
• Do not hook three hooks onto the circuit board for testing
• Do not test live circuit boards
• Otherwise, the tester will be burnt down. Burning the tester is the buyer’s reason.
• When the voltage and internal battery are below 3V, please charge before use.
• Please use 5V battery or USB port to charge.

LCR-T7 / LCR-TC1:color screen / Product chip: High-performance mcu, two functions are the same! T7 is slightly faster! The TC1 screen is slightly larger and they are all powered by lithium batteries. In addition to measuring resistance, capacitance, inductance, diodes, MOS transistors, thyristors, it can also measure additional voltage regulators, infrared decoding (limited to for Hitachi format)

LCR-TC1

Feature

• Self test with automatic calibration
• Size: 70*90*26m/ 2.71×3.58×1.10 inch
• Display:TFT Screen, Color Screen
• Diode Range: less than 4.5V
• Zener Diode:Transistor Detect Area: 0.01-4.5V
• Zener Diode Detect Area: 0.01-20V
• Triac Range: IGT less than 6mA
• Capacitance: 25pF-100mF
• Resistor: 0.01-50MΩ
• Inductance: 0.01mH-20H
• Power Voltage: 3.7V
• Product chip: High-performance mcu
• Power: Built-in Rechargeable Lithium Battery
• Measurement results using TFT graphic display (160×128)
• One-button operation
• Auto power off (timeout setting)
• Built-in high-capacity rechargeable lithium-ion battery
• Lithium-ion battery voltage detection
• Support Chinese and English
• Warning: Built-in lithium-ion battery, it is strictly forbidden to immerse the tester in water or near heat source!
• Warning: For your personal safety, please strictly observe the specifications and precautions for using lithium-ion batteries!

Transistor Detection

• After the power-off state or test is completed, put the test component into the transistor test area of the test socket, press the lock handle, press the multi-function key, the tester automatically measures, and the measurement result is displayed at the end of the test.
• Warning: Always discharge the capacitor before connecting them to the tester! The tester may be damaged before you turn it on!
• Warning: We do not recommend using a tester to measure the battery! The battery voltage must be less than 4.5V, otherwise the tester may be damaged!
• Component placement:
  The test socket is divided into transistor and Zener diode test areas, as described in 1.1.
  Note: Do not perform other operations during the calibration process to avoid affecting the calibration accuracy!

Packing List

• 1 x multifunction TFT transistor tester
• 1 x electronic component group
• 3 x test hook
• Short the three test sockets, press the multi-function button shortly, and the tester will automatically calibrate.
• No other operations are required after disconnecting the short wiring according to the prompt during the calibration process.